Performance Testing

The performance testing of injection includes electrical characteristics, accuracy, the tolerance of high temperature, low temperature, pressure as well as leakage, durability and others working conditions testing. These conditions of each injection will be tested before our injections are sent to customers.

 

Above are the tests needed to be done after the injections are finished producing. However, regular checking also very important to keep the injection perform well.

 

In order to make sure the injection works normally, there are some parts of injection needed to be checked regularly and before installing to injector.

① Check whether there is deformation, cracking, thread damage, quenching, leakage and rust in the guide sleeve, spring, gasket and tight cap of the injection. The tight cap of the injection must be replaced after being disassembled for more than 5 times, as shown in the following.

② Replace the tight cap of the injection and the copper gasket of the injection

③ Check whether the gap between the injection needle and the injection shell is within the standard range and whether it reaches the standard for use

④All parts should be examined for wear under a microscope at least 20 times larger

⑤ injection tight cap deformation, cracking, thread damage, quenching, leakage, will lead to black smoke vehicle cap, fuel injector damage.

⑥injector opening pressure greater than or less than the specified range may cause injector damage.
⑦ Failure to replace wearing parts in time during maintenance may lead to fuel injector damage.

 

These are some precautions you need to know to maintain an injection. If there are more questions about injections and other problems, you are welcomed to contact us, carfuelinjection.com will do the best to help you solve your problems.